- #New punjabi song 2020 how to
- #New punjabi song 2020 mac
VLAN must exist locally on the switch the SVI is on. Must have one port (Access or Trunk) in an STP FWD state in the VLAN corresponding to the SVI configured. #New punjabi song 2020 how to
SVI’s are much more common and likely what will be found both on the TSHOOT exam and in real world networks, and are fairly straight forward, the following are some necessary configs for them to work / how to verify them / possible issues.įor an SVI to Up/Up and Functioning properly Switched Virtual Interface (SVI) Troubleshooting
#New punjabi song 2020 mac
Use the above config for each VLAN / Subinterface on the physical interface that is connecting to the Trunk Uplink to the Routerĭynamic Trunking will not work, ISL will not work, and you will want to confirm the Trunk allows traffic and IP addressing is correct / PC’s are connect to interfaces on the switch in the proper VLAN (“sh mac address-table dyn”), etc. Make sure no VLANs are being disallowed from traversing the Trunk. Create Trunk Nonegotiate (not dynamic at all) use Dot1q encap. 
Default Gateway will be Routers sub-interface for ROAS. Make sure IP Address, Subnet mask, and Default Gateway are correct. Router on a stick is used when the Cisco switches are running at Layer 2, and have to uplink to a Router to handle 元 routing between VLANs, so just a quick review of how to even configure ROAS since it is not a normal configuration in modern networks. Quick review of Router on a Stick Troubleshooting 
Though router on a stick is not on current TSHOOT Topologies that I see, and will more likely be SVI’s that you are troubleshooting, I wanted to add some notes on here pertaining to that subject as well for possible dated real life scenarios of dated networks.
0 kommentar(er)
